Handheld Screwdriver With Feeder For M2 -M6 Screws Feeding And Locking

Intro:

The automatic locking screw machine is mainly composed of two parts: 1. The feeding system sorts the screws and distributes the screws through the distributor, and the pipe sends the screws to the screwdriver. 2. Use an electric or pneumatic screwdriver to lock the screws into the locking system in the product. Compared with the locking screw action of holding the screw in one hand, holding the electric screwdriver or air screw in the other hand, the automatic lock screw machine can free one hand out, and only need a hand-held screwdriver to align the screw hole to lock the screw. After locking a screw, you only need to lift the screwdriver to align the next screw hole to lock the screw. The machine will automatically transfer a screw to the screwdriver at the moment of lifting the screwdriver, wait for the next screw to be locked, and repeat.

Suitable:

Screwdriver with screw holder and screw automatic feeding system, the screws will be meet below requirements.

1. b>=1.3* D
2. Screws should be M2 to M6. 2mm<=d<=6mm
3. 3.5mm<=D<=11mm (D can be Max20mm. It should be better within 3.5-11mm.

Specification:

Handheld Screwdriver With Feeder For M2 -M6 Screws Feeding And Locking

Features:

Screwdriver with screw holder and screw automatic feeding system

1. Automatic screw feeding, sorting and locking for various shapes screws. One-hand operation.

2. Torsion precision and convenient adjustment, ensure the quality of screw locking

3. Turbine feeding, low volume and noise, convenient maintenance. Light weight and small, mobility and save space.

4. Warning function when lack of screws.(Acousto-optic alarm)

5. High efficiency. No need to pick up screws, move screws and put screws. Just need to lock the screws aimed at the screw hole.

6. Sensor controls screws feeding one by one to avoid feeding repetition.

7. Can lock screws very fast, around lock 60 screw per minute.

Working conditions:

1, Screw specification requirements:
The screw length should be over 1.3 times greater than the screw cap’s diameter.

If the screw cap is greater than the screw length, the screw cap may come out first, because the screw will turn over during feeding screws.

The screw length should be less than 45mm.

Welcome to contact our Screwdriver with screw holder and screw automatic feeding system